Spray Foam Insulation, Foam Insulation, 1 component Spray Foam, Spray Foam Insulation, spray Foam System, Handi-Foam®
INDUSTRIAL INSULATION SALES, INC.
Insulation Distributor & Fabricator Email: info@industrialinsulation.com
Micro Lok Handi Foam Your Insulation Specialists for:
Pipes Boilers Equipment Ducts Fire Stopping • Fabrications
Armaflex FOAMGLAS
Spray Foam Insulation, Foam Insulation, 1 component Spray Foam, Spray Foam Insulation, spray Foam System, Handi-Foam®

One Component Spray Foam Insulation System - Handi-Foam®

One-Component Spray Foam Insulation Kit by Handi-Foam®

1-Component Spray Foam insulation kit by Handi-Foam® , Inc. is UL-classified polyurethane foam. 1 Component Spray Foam Insulation is used to fill, insulate and seal beneath base plates, mud sills, top plate penetrations, corner joints, T-joints, exterior cracks, around utility panels, pipes, duct penetrations, etc.

Handi-Foam® 1-Component Spray Foam insulation dries tack free within 10 minutes or less depending on moisture and temperature condition, is cuttable within 1 hour and fully cures in 12-24 hours.

Handi-Foam® 1-Component Spray Foam insulations optimal application temperature is between 65 F–100 F. Air temperature during application can range from 40F to 115F. Cured foam is resistant to a wide range of temperatures (+200 to - 200 F) and unlike many can spray foams it will repel moisture due to it’s unique closed cell properties.

IMPORTANT:
Always read all operating, application and safety instructions before using any products from Fomo Products, Inc.

Use in conformance with all state and local building codes and federal regulations; obtain building code approvals before use, and follow all safe handling requirements.

User of this product must determine suitability for any particular purpose, including, but not limited to, structural requirements, performance specifications and application requirements prior to installation and after product has been properly applied.

One Component Cylinder Spray Foam Insulation

Product Data Sheet & SDS

Yield Calculator 

Main Office:
2101 Kenmore Ave.
Buffalo, NY 14207
Ph: (716) 874-7278
Fax: (716) 871-3498

Branch:
631 Trabold Rd.
Rochester, NY 14624


Page Links
Home
Pipe Insulation
Blanket & Roll Insulation
Board Insulation
Duct Wrap, Liner, Board, HVAC
Insulation Jacket & Fitting Covers
Spray Foam Insulation
Firestop & Fire Protection
Fabricated Insulations
Pre-insulated Pipe Saddles
Insulation Coatings & Adhesives
Application Accessories
Clear-Out Insulation Items
Insulation Comparison Chart
Manufacturers Links
Request Credit Application
Submittal Sheets
Energy Calculators