Spray foam Insulation, Foam Insulation, Can Foam Insulation, One-component Spray Foam, Straw Foam Insulation, Gun Foam Insulation, HandiFoam®
IIS, Inc Insulation Distributor & Fabricator
Ph: (716) 874-7278  •  Fax (716) 871-3498
Micro Lok Handi Foam Your Insulation Specialists for:
Pipes Boilers Equipment Ducts Fire Stopping Fabrications
Spray foam Insulation, Foam Insulation, Can Foam Insulation, One-component Spray Foam, Straw Foam Insulation, Gun Foam Insulation, HandiFoam®

Spray Foam Insulation - 12 oz. & 24 oz. Cans - HandiFoam®

One Component Straw / Gun Spray Foam Insulation

1-Component Straw / Gun Spray Foam insulation by HandiFoam® is a UL-classified sealant. Designed for sealing cracks, seams and smaller gaps, it will eliminate drafts, block insects, deaden sound and repel moisture.

One-Component spray foam insulation cures when moisture in the air reacts with the chemistry of the foam. HandiFoam® One-Component Spray Foam insulation cures to in place densities between 1.0 and 2.0lbs per cubic foot (16.02 to 32.04kgs per cubic meter) and carry an R-value of 4 to 5 per inch (2.54cm). This spray foam will cure tack-free in 10 minutes, can be trimmed or cut in 1 hour and will reach full cure in 24 hours or less.

Optimal application temperature is between 65 F–100 F. Air temperature during application can range from 40F to 115F. Cured foam is resistant to a wide range of temperatures (+200 to - 200 F) and unlike many can spray foams it will repel moisture due to it’s unique closed cell properties.

Straw Foam cans include an attachable straw and trigger assembly used to dispense the foam.


  • Filing cracks & voids

  • Sealing around HVAC units

  • Filing gaps around pipes

  • Fixing small holes & other damage

Always read all operating, application and safety instructions before using any products from ICP Adhesives & Sealants.

Use in conformance with all state and local building codes and federal regulations; obtain building code approvals before use, and follow all safe handling requirements.

User of this product must determine suitability for any particular purpose, including, but not limited to, structural requirements, performance specifications and application requirements prior to installation and after product has been properly applied.

Straw / Gun Spray Foam Insulation

Product Data Sheet & SDS

Yield Calculator

Main Office:
2101 Kenmore Ave.
Buffalo, NY 14207
Ph: (716) 874-7278
Fax: (716) 871-3498

631 Trabold Rd.
Rochester, NY 14624
Ph: (585) 247-0852
Fax: (585) 247-9354

Page Links
Pipe Insulation
Blanket & Roll Insulation
Board Insulation
Duct Wrap, Liner, Board, HVAC
Insulation Jacket & Fitting Covers
Spray Foam Insulation
Firestop & Fire Protection
Fabricated Insulations
Pre-insulated Pipe Saddles
Insulation Coatings & Adhesives
Application Accessories
Clear-Out Insulation Items
Insulation Comparison Chart
Manufacturers Links
Request Credit Application
Submittal Sheets
Energy Calculators